Powertrax No Slip Traction System

DON'T GET STUCK AGAIN!!
The No-Slip Traction System will significantly enhance the traction of your light truck, sport utility vehicle, or van by sending the engine power to the wheels that need it most. Yet on dry pavement, the No-Slip Traction System will allow for full wheel differentiation to prevent additional tire wear. Operation is smooth, quiet and dependable.
UNMATCHED PERFORMANCE!!
The No-Slip Traction System performs under a variety of rugged conditions. Whether it be snow, ice, mud, sand, gravel, or the street, the No-Slip Traction System will help get you to your destination. Its extremely rugged design has been tested and proven worldwide.
WORK OR RECREATION- NO-SLIP TRACTION SYSTEM GIVES YOU THE TRACTION YOU NEED!!
Towing your boat, RV, or trailer is no problem with the No-Slip Traction System installed. Never get stuck on the boat ramp again. It's also ideal for vehicles with plows or that operate in construction areas.

Where do you need the No-Slip Traction System?

The Powertrax No-Slip Traction System is the latest design in traction adding differential technology. It combines the smooth operation of a limited-slip differential, with the traction performance of a locking differential. A precise synchronization mechanism eliminates the ratcheting sounds typical of other locking differentials. Special gear and spring design reduce the backlash and therefore driveline windup. Only ultra strength material is used which is 67% stronger than titanium. Installation is simple because no ring and pinion set-up is required. In addition, no special tools or oils are needed. Step by step model specific instructions are provided with every kit. The No-Slip Traction System is the ideal solution for just about any light truck, sport utility, and muscle car on the road today. Whether you need the safety of added traction for daily commuting, recreation, work, or just so your muscle car puts power to the pavement instead of burning one wheel up, the No-Slip Traction System is your answer.

A key feature of the Powertrax No-Slip Traction System is that it installs easily in the existing differential case so there is no need to realign the ring and pinion gears. 2-pinion differentials are the easiest to install and do not require removal of the case. 3-pinion and 4-pinion differentials use split cases, requiring case removal. However, because the case is not replaced, all setup parameters are preserved so the installation is still not difficult. The entire installation can be completed in about an hour with basic tools. No special setup is required. At special events, Powertrax demonstrates the ease of installation by installing the Powertrax No-Slip Traction System in prepared vehicles in under 5 minutes.

Limited-slip/posi and centrifugally activated differentials can be as easily upgraded with a Powertrax No-Slip Traction System as can open differentials. When upgrading a limited-slip/posi differential, it is only necessary to remove preload springs before removing the spider gears, and to remove the friction plates after removing the side gears. For centrifugally activated differential upgrades, it is necessary to remove the governor counter weight and tumbler assembly before removing the spider gears (GM Gov-Lock). Powertrax provides a special tool with each centrifugally activated differential model that easily facilitates this step.